You can suport my work by donations.

Saturday, March 5, 2011

How to reset the fusing unit - Bizhub C203 / C253 / C353

How to reset the fusing unit - Bizhub C203 / C253 / C353

No need to remove the fusing unit from machine.

You will need a 80mA Fuse(50mA, 63 mA it also good).

If you use a 100mA or higher value, you risk to burn the motherboard of the copier(or ICP5).

 1.Shutdown the machine.
 2. Open the front cover were the iu and toner cartrige are located.
 3. Remove the cover as shown in the picture.

4.Cut the wires 2 and 3 as long as you can. And connect them with the fuse. You can use something like shown in the picture below(or you can solder the fuse directly).




5. Insulates connections and close all doors.
6. Start the machine, wait to warm up, check if the fusing unit is reseted and if everything is ok shutdown again, remove the fuse.

And thats all folks!

13 comments:

  1. Thank you for this tutorial on resetting the fuser unit.

    ReplyDelete
  2. I just burned out my motherboard!!! I will sue you for this!!!

    ReplyDelete
    Replies
    1. you can not burn the motherboard. in the worst case you can burn a fuse on the motherboard(ICP 5 - 2,5Amps).

      Delete
  3. Thanks for the tip.

    ReplyDelete
  4. has anyone done this method? is it safe?

    ReplyDelete
  5. after cut off the wire and connect them on which side ?

    ReplyDelete
  6. Thank you very much for the info, the fuser unit has been resetted and it's working fine. Nothing has been fried during the process.

    Thanks a lot!!

    Cheers

    ReplyDelete
  7. how to reset imaging unit for konica minolta c-253

    ReplyDelete
  8. after cut off the wire and connect them on which side ?

    ReplyDelete
  9. I would also appreciate if you could clarify which side we're connecting?

    ReplyDelete
  10. I would also appreciate if you could clarify which side we're connecting?

    ReplyDelete